Manual / EN CONTENT 4 x Screw UH 6.0 x 60 mm 4 x Rawlplug Ø8.0 mm 2 x Adjusting fittings 1 x Suspension rail for wall 2 x Spacer knob Note! It is not necessary to use the outermost holes. They may be used instead of the adjusting fittings. MOUNTING 1. Mark the placing of the suspension list through the two large holes at the ends. Mark the centre of the hole. *2. Drill Ø8 mm holes at the marking and insert Ø8 mm plugs. *3. Mount adjusting fittings in the suspension rail and fasten it to the wall by means of 2 pcs. Ø6.0 x 60 mm screws. 4. Place a spirit level on top of the suspension rail. If the list is not horizontal, loo- sen the screws and adjust the suspension rail by turning the adjusting fittings. 5. Drill holes in the wall with a Ø8 mm wall drill at the two centremost holes of the suspension rail. Note! Drill through the suspension rail while it is hanging on the wall. 6. Insert plugs in the holes (with a screw it is possible to push the plug completely into the wall). Then fasten the two centremost screws. 7. Mount the suspension rail on the wall. 8. Mount the spacer knobs in the two lower corners of the back plate. *These instructions are based on concrete walls or brick walls in good condition. In case of a porous wall use longer screws. In case of wooden walls plugs are not needed, but instead you can pre-drill with e.g. ø3 mm drill. For other types of wall as for instance plasterboard, use the screws and plugs suitable for that.
Download PDF fil