Manual / EN CONTENT 4 x Legs 16 x 4.2 x 13.5 mm 16 x Countersunk screw Ø4,0 - 15 mm for retrofitting FITTING If the legs are ordered together with a module, there will be 4 holes in each corner of the module bottom to fit the legs. Use 16 pcs. 4.2 x 13.5 mm. Drilling template RETROFIT 1. Determine position If the module is placed up against a wall, it can be an advantage to move the rear legs a bit inwards under the module. Then the module can be placed quite close to the wall, while the legs and skirting board do not touch each other. 2. Marking up If the legs are ordered for retrofitting, please use the en- closed pattern to determine the position of the legs. 3. Fastening of the legs The legs are fastened by using the enclosed screws ø4 x 15 mm. Be aware not to strip the screws. Always use a manual screwdriver for the final re-tightening of the screws. 4. Adjustment The module is levelled by using the adjusting screws in the legs. NOTE: Units from width 69,6 cm and upwards with legs should be fitted with support rail under the bottom.
Download PDF fil